Fire-resistant sealant for temperatures up to 1200 °C
Ceresit CS 38 is an inorganic-based sealant with special thickening additives that cures by evaporation of water to form a solid seal or provide a crack-free bond with high temperature resistance.
Special formula for joints exposed to slight vibration and temperatures up to 1200 °C.
- Forms a strong seal/bond resistant to high temperatures, with a convex shape, resistant to extreme temperatures up to 1200 °C
- Flame-resistant, good adhesion to the most common construction substrates, does not shrink, dries without a sticky surface
- Emits no fumes, can be painted
Field of application:
- Filling cracks in ovens.
- Sealing joints exposed to flame
- Sealing and laying refractory bricks
- Fixing refractory slabs
- Chimneys and flues
- Sealing and bonding for: stoves, boilers, ovens, chimneys and grates
- Gas outlet pipes
Instructions for use:
Surface preparation
All surfaces must be solid, dry and clean, free of dust, grease and anything that could prevent adhesion.
For strongly absorbent surfaces, lightly dampening the surface improves adhesion.
The product is supplied ready to use and can be applied from the cartridge with a standard pneumatic or manual gun.
Cut off the tip of the cartridge cap above the thread, screw on the plastic nozzle and cut it at an angle according to the desired width. Insert the cartridge into the gun and fill the joint or crack on the substrate, making sure the product presses firmly against the sides of the joint/substrate and that no air remains.
Where necessary, smooth with a spatula before the paste surface dries.
Let the paste cure for at least 2 days before slowly and gradually raising the temperature, so that bubbles do not form.
More than 72 hours of curing may be needed under certain conditions.
Do not allow the cured product to be exposed to prolonged wetting.
General information:
Substrates must be clean, dry, solid, free of oils, grease, dust and loose particles.
Residues of oils or grease are cleaned with acetone, alcohol, isopropanol or special cleaners.
The product is suitable for a wide variety of construction materials, for example:
Concrete
Brick
Refractory brick
Glass
Iron
Steel
Galvanised steel
Anodised aluminium
Storage:
12 months from the production date if stored in unopened original cartridges, in a dry place protected from direct sunlight, at temperatures between +5 °C and +25 °C.